Visit The Dirt Forum for More Information

Author Topic:   camaro steering questions
neil rucker
Member
posted March 02, 2003 10:04 PM
is any one familar with adjustable centerlink available from "HOWE" will it work on 70 thru 81 camaro? nice piece. any help apreciated. thanks. neil


66jj
Member
posted March 02, 2003 10:20 PM
thats what its for.

its not necessary for good geometry by any means....

jeff

neil rucker
Member
posted March 02, 2003 10:24 PM
jeff, how can i set this car up with proper geometry without using the "HOWE" part? thanks neil


c21
Member
posted March 03, 2003 10:41 AM
c21 can you give us more details on this


c21
Member
posted March 04, 2003 10:45 AM
c21, thanks alot for your help. neil


leftturn29
Member
posted March 11, 2003 10:56 PM
neil,
did you ever find a price for the adjustable centerlink--i can't seem to find one anywhere--noone around here has even heard of them yet--thanks for your help--leftturn29


quote:
Originally posted by neil rucker:
c21, thanks alot for your help. neil



c21
Member
posted March 12, 2003 10:04 AM
. "HOWE RACING INTERPRISES" Beaverton, Michigan (517) 435-7080 part# 23396 $169.00


nw15x
Member
posted March 13, 2003 08:19 PM
can you bend your spindle arms down to compensate for tow in rather than raising the drag link.


neil rucker
Member
posted March 14, 2003 05:33 PM
im just learning,but i think you could. it would probably weaken the spindle alot though. neil


leftturn29
Member
posted March 14, 2003 10:48 PM
Thanks for the info guys, I'll let you know how it turns out....
quote:
Originally posted by neil rucker:
. "HOWE RACING INTERPRISES" Beaverton, Michigan (517) 435-7080 part# 23396 $169.00



c21
Member
posted March 17, 2003 11:38 AM
quote:
Originally posted by nw15x:
can you bend your spindle arms down to compensate for tow in rather than raising the drag link.

yes you can, but it should be done carefully (cool slowly in sand after heating with a torch, or shop press it with lots of protective gear).

however, changing the inner pivot locations is a far better solution IMO because it does not require that you have a collection of spare spindle's pre-bent (identically) for quick repairs.

c21



Back to the Archives