Visit The Dirt Forum for More Information

Author Topic:   roll centers
neil rucker
Member
posted February 26, 2003 05:38 PM
what is the frt RCH (rollcenter height) on a stock 76 camaro? can anyone tell me what change was made by simply putting AFCO 20038-1 lower balljoints in the lowers, and AFCO 20032-1 upper balljoints in the upper arms (stock mount uppers from "SPEEDWAY MOTORS" what is my new front roll center location? is this impossible to determine without actualy finding all the angles and measurements and drawing it out on paper? i wont get any sleep until i find out. any help greatly appreciated. thanks neil


justin
Member
posted February 26, 2003 07:02 PM
I may be mistaken but I believe the stock front roll center on your car is around .5" above ground, not sure about lateral position. After the ball joints added I would think that you could not get an accurate response unless you actually plotted out your roll center. Maybe someone else can give you a better answer on this because I may be wrong. Sorry if I didn't help very much.

Justin

neil rucker
Member
posted February 26, 2003 08:51 PM
thanks for your help justin. neil


Back to the Archives