Visit The Dirt Forum for More Information

Author Topic:   pinto spindles on camaro
neil rucker
Member
posted February 25, 2003 10:00 PM
want to put pinto spindles on camaro stub any help would be appreciated thanks


15a
Member
posted February 28, 2003 02:53 PM
very interested in this info! flexiflyer has the answers, but they are not going to tell you what you are buying, only a very breif description of how to use there stuff. if they tell use anymore, than we figure out what they went to alot of time and exspense to figure out. please PM or call anytime 770 740-1532 thanks vere much. neil


Donnie Ross
Member
posted February 28, 2003 09:22 PM
I used this setup when I ran bomber ,had the spindles reamed to fit my ball joints, used 5/8 bolt with shims and a hiem joint to set bumpsteer, if this is not legal for you you would have to play to get it right with stock tie rods not sure, handled a lot better than my limited late with a camaro stub and impala spindles. good luck.


neil rucker
Member
posted February 28, 2003 09:36 PM
thanks for your reply donnie, what kind of upper and lower ball joint to use? i dont know as i havent really looked at any of these spindles yet, but there not as tall as a stock camaro spindle are they? do they lower the car thus raising the roll center? as always, thanks very much. neil


15a
Member
posted March 01, 2003 12:04 AM
DMS CEO interested in talking to you about this. please call me at (770) 740-1532 anytime. thanks neil


Donnie Ross
Member
posted March 02, 2003 02:46 PM
the car had mopar ***** in ball joints, at the time didn't know any thing about roll centers so don't know the hieght never measured. local shop just reamed the spindles to fit the ball joint,larger joints on the bottom smalls on top don't know #s but any speed shop should know em, ride ht. was lower than many i raced against looked like a pavement car but it worked.


15a
Member
posted March 05, 2003 11:40 PM
What the heck is this "call me and ill sell you something" garbage.
I THOUGHT THIS FORUM WAS FOR THE FREE EXCHANGE OF IDEAS..

DMS ; DO YOU SPONSOR THIS SITE?

neil rucker
Member
posted March 06, 2003 08:35 PM
dms, if you will pm me with your phone number i would like to discuss this info with you. (pinto spindles on camaro stub) if you charge for this info, i have to be able to talk to you directly. thanks. neil


NYhick
Member
posted March 06, 2003 09:32 PM
I tend to agree with widebody, if we all charged for the information we share with each other through our trials and tribulations then what would be the point of the site???????? Just post the stinkin information for the guys already!!!!


15a
Member
posted March 08, 2003 10:01 PM
tHERE ARE 40 POST RE THIS QUESTION IF YOU GO TO BUMP STEER MARCH 5 03 IN THE MODIFIED TECH TALK. AND IT WONT COST YOU A DIME.
I AGREE, THIS INFO FOR CASH IS A BAD PRECIDENT TO BE SETTING, JAMMIN WHERE ARE YA


jammin
Administrator
posted March 09, 2003 07:58 AM
That aint gonna happen guys. I think DMS was pullin your chain, but I will get him to post that info.

jammin

15a
Member
posted March 11, 2003 11:48 PM
if anyone is serious about racing, call me. 770 740-1532


Back to the Archives