Visit The Dirt Forum for More Information

Author Topic:   Motor setback
Matt22
Member
posted January 24, 2003 11:23 AM
I built two small pods out of 1 1/2" tubing which I welded to the crossmamber. (You may have to do a bit of re-construction on your where they'd made room for the fuel pump.)They are set 22 1/2 inches apart, measuering from center to center. A level line from the tops of them will be 11" above the crossmsmber. The tops of these had a nut welded to a washer (both 1/2") and welded to the tubing. Buy yourself a couple of solid steel motor mounts and (I used) the original trans crossmamber. Be sure to fab yourself a solid mount there too! Good luck!


Back to the Archives