Visit The Dirt Forum for More Information

Author Topic:   solid lifter cam with hydraulic lifters?
dode
Member
posted January 16, 2003 06:52 PM
Can I do this? How will it work? I have a sweet solid lifter cam, but have to run hydraulic lifters. Thanks.

John

racer17j
Member
posted January 16, 2003 08:01 PM
my buddy has done it before and it worked real well for about 10 laps


dode
Member
posted January 16, 2003 08:03 PM
And? LOL


racerss10
Member
posted January 16, 2003 10:40 PM
I have a buddy that does it in his i stock and modified he said it just brings the lift down some. I dont know how it would change the lift but that is what he said.


racer17j
Member
posted January 17, 2003 03:21 AM
and it turned into a flat cam it might have been something he did to it tho but i have heard of guys doing it with success but we have also ran hydro's against solid and kicked but llike 10 said it will change the lift of the cam so you might be better off just goin with a hydro thats close to eliminate any problems

[This message has been edited by racer17j (edited January 17, 2003).]

Pickel
Member
posted January 17, 2003 09:56 AM
I did it for about 3 years.. worked great..The only thing I notice was the motor did not rev as quick as it dose with solid ...I used the rhodes racing lifters..


chvydty
Member
posted January 21, 2003 11:52 PM
The federal mogul (TRW's) anti-pump up lifters need to be treated almost like mechanicals. The bleed-down rate is next to nil. Ya gotta put them in a vise and crank the life out of them just to get them to bleed a little. These might be your best bet if your gonna give it a shot.


left turn
Member
posted January 22, 2003 09:05 PM
doing what?


Victory By Design 27K
Member
posted January 29, 2003 07:15 PM
you can use the solid with those lifters as long as you leave 20 thousandths clearance to let the lifter prime up. after it is prime it acts as a solid


rico 08
Member
posted January 29, 2003 08:59 PM
hydraulics have a slight ramp to pump up the lifter slightly that's why u can't put solids on a hyd cam,the only problem that may happen is the lifters may not give full lift out of cam if they are not ramped up?


Back to the Archives