Visit The Dirt Forum for More Information

Author Topic:   Hobby stock question
moedemarcus
Member
posted January 07, 2003 03:43 PM
the crossmember will work, and the drive shaft should work unless you was useing a automatic from a truck before. the tail shaft from a truck trany is alittle bit longer than one from a car. hope this helps. almost forgot, you will have to change the pinion u-joint, the cups on the 9 inch are alittle bigger than on a metric 10 bolt. they do have u-joints that will convert without any modification, i just dont know the part #

[This message has been edited by dreamcatcher (edited January 07, 2003).]

Back to the Archives