Visit The Dirt Forum for More Information

Author Topic:   12 Bolt Swap in Monte Carlo
ars
Member
posted December 24, 2002 10:34 AM
I tried this on a '76 Cutlass, the lower trailing arms bolt right up, the uppers are a problem. The car you have the upper trailing arm spread from the center section to the mounts in the frame, the rear end I had,a 12 bolt from a '65 Impala, the upper trailing arms were straight to the frame with a panhard bar. I felt it was a lot of work for a little gain.. if any. In the end I wished I'd not done it. loojack


LUBEGUY07
Member
posted December 24, 2002 04:25 PM
im doing the same thing to my car, buty its a metric car, and I am using a 12 bolt out of a 68 chevelle bolts right in. The only problem its a few inches wider than the origainal rearend.



Back to the Archives