Visit The Dirt Forum for More Information

Author Topic:   pinto spindles what rotors
b00
Member
posted November 22, 2002 10:26 PM
Is it my imagination or can metric rotors be run on Pinto spindles. I heard somewhere that this could be done using stock or close to (A3 and A6 BCA) bearings?

Jim

2nd2none
Member
posted November 24, 2002 02:08 PM
quote:
Originally posted by 99EMBREY:
WE RUN MUSTANG II ROTORS FROM SPEEDWAY. VERY SMALL AND LIGHTWEIGHT. YOU HAVE TO BUY SPECIAL CALIPER BRACKETS ALSO.

what brake caliper's are used with this setup? Is the the big GM calipers?



CUSTOMPERFORMANCE
Member
posted November 24, 2002 02:41 PM
small gm metric calipers with the same bracket as if you used the granada rotors


Pickel
Member
posted November 24, 2002 07:58 PM
When I ran my Pinto spindles I ran my GM rotors with the GM calibers. The best way to mount the rotors is to get the race number and barren number off the Pinto rotors and use those in the GM rotors. I believe the Areostar rotor will work but I haven't looked into that yet.


HRT187
Member
posted November 25, 2002 11:35 AM
quote:
Originally posted by CUSTOMPERFORMANCE:
small gm metric calipers with the same bracket as if you used the granada rotors


A lot lighter too.