Visit The Dirt Forum for More Information

Author Topic:   inner tubes
car311
Member
posted October 23, 2002 08:19 AM
Has any one ever used tubes in their tires? At least on the front?


George Gilliland
Member
posted October 23, 2002 12:48 PM
Not good. Years ago on the stock car I used to run tubes all the time, but with the low tire pressures on the modified there is too much, deflection, heat and abrashion between the tire and tube. I had to run a tire with a tube the other day and so I put it on the left front and ran the pressure a little higher than normal and it worked. I sure would not do it on a regular basis and never never on the right rear.


brownstone
Member
posted October 23, 2002 01:02 PM
my thoughts exactly, I would never run one on the back, but i have several tires that only have 1 race on them that got knocked down during a race. $85 dollar tires with one race are too big of loss to disgard. The front left seems like a good place since it just skims the ground anyway.


outlawstock17
Member
posted October 23, 2002 02:45 PM
i know what you're saying george. the tube and the tire don't like each other. even with baby powder, they will chafe each other and eventually wear a hole in the tube, especially on the RR. however, i've had good luck running tubes on the front of the car.


Geffy95x
Member
posted October 23, 2002 04:03 PM
I always run tubes on the front and have never had a problem ,Have tried them on the rear once with no success.
With low pressures(15lbs)and a rough track I have blown two tires off the bead on the right front without tubes.With tubes since then on a rough track no problems, Gives me the extra confidence when throwing it in on a rough track.


Racer14K
Member
posted October 24, 2002 02:45 PM
I have run tubes in both rears several times without problems ( hoosier e-mods LR 10lb / RR 12lb ). The trick is getting the right size tube, if it's not big enough it will not contact the full width of the tread patch, or both sidewalls. I have not had to use any for awhile now so I can't remember what size they were. It was either a truck or tractor tube.

[This message has been edited by Racer14K (edited October 24, 2002).]

PAUL BOUWMAN
Member
posted October 24, 2002 07:38 PM
quote:
Originally posted by car311:
Has any one ever used tubes in their tires? At least on the front?

i have run tubes everywhere on all my cars and have not had a single problem yet
the only thing i make sure to use a valve stem protector


redneck bubbas racing
Member
posted October 24, 2002 10:47 PM
I tried running tubes in my car, didn't work too well. I found out that the tractor type tubes do work best. I ended up only running one on the right front, the rears always popped, and it wasnt needed on the left front.


uforacing51
Member
posted October 25, 2002 08:14 PM
I found that I could run with one on the RF and the rest just didn't need them. this is of course assuming that you have a beadlock on the RR. Left side doesn't need them


fordsblow
Member
posted October 26, 2002 01:31 AM
I've ran as low as 6 lbs in my left rear with a tube on my IMCA Modified and never have had a problem with the tube.
I only use Carlisle brand implement tubes they are part #11L-15/16 SL
TR-218 A Valve
Product code : 032247
Here's a link to their site http://www.carlisletire.com/

These tubes are thicker than a normal street tube and the valve stem has a nut that clamps it to the rim.

To everyone that has had a tube problem, was the valve stem area messed up? You might hve spun the tire on the rim and pinched the valve stem.

[This message has been edited by fordsblow (edited October 26, 2002).]

George Gilliland
Member
posted October 26, 2002 10:17 AM
fordsblow: What store or outlets carry Carlisle Tubes? Thanks.


fordsblow
Member
posted October 28, 2002 12:33 AM
George, I'm not sure what brand the store is I think it was a Auto Value parts store. I stop in there tomorrow and get some more info.
Ken