Visit The Dirt Forum for More Information

Author Topic:   Any Crown Vic Stubbed Mods out there??
Tom Asmus
Member
posted August 10, 2002 09:53 PM
Curious to know if any one else is runnin a mod with a 79-up Ford Crown Vic Stub! We are playin with some spindle combonations, and are curious if we are on the right track!


racer17j
Member
posted August 11, 2002 12:33 AM
i think cobra chassis are running some fords from what i have heard


ford5
Member
posted August 11, 2002 12:53 AM
Tom, we are running that frame and are using pinto spindles and have had the best luck with them they are what i would recommend.

ford5
the M@M cars around this area are all using the spindle that came on that frame, they are very fast too but i think they are a modified version of stock tho, as the steering arm is shortened


Tom Asmus
Member
posted August 12, 2002 07:44 PM
Okay 5, what inner tie rod ends are you using! I have been at the parts store all day and I cant find nothing with the same taper as the LTD! I am trying to get ready for a Modified special here Fri night and no luck. Any help would be greatly appreciated!!


BigBlueFord
Member
posted August 13, 2002 07:01 AM
Just bought a M&M modified. Ours runs an 80 - 83 crown vic stub, lower A-arm, and spindle.

Our car uses a stock Ford outer tie-rod end on the inside and a hiem with a thru bolt on the spindle end. The steering arm on the spindle has been shorten. The tie-rod has metric LH threads on the 80 - 83 Ford tie-rod end and I think 5/8" RH threads on the hiem end.

Not a 100% sure on the year range yet but at least 80 - 83 Ford Crown Vic and Mercury Marquis stubs are the same.

------------------
I drive a FORD so I have time to work on Chebby's.


Tom Asmus
Member
posted August 13, 2002 09:30 AM
Thanks for the info Big Blue but I have messed with these cars for a while and we found that the tie rodends are metric thread. I will try again to see if the swedged tubes I have might go on! I had the pinto spindles all fitted to the car! Any help is appreiciated!!


BigBlueFord
Member
posted August 14, 2002 09:16 PM
I just reread my post. What I meant to say was the swedged tie rod tube has metric LH threads on one end and SAE RH threads on the other end. M&M has the swedged tie rod tubes specially made.

That way they can run the Ford metric thread outer tie rod end and a 5/8" RH thread hiem with a thru bolt on the spidle end.

From what I've been told the crown vic spindles are forged and not cast. So I guess the spindle steering arm can be cut-off, shortened, and then welded back on to the spindle. Really seems to speed up the steering. About 3/4 of turn lock to lock.

KK17
Member
posted August 16, 2002 12:41 PM
tom ,we are using stock ford crown vic tie rods, they hold up well, better than swedged tube\hiem combo and cheaper too.