Visit The Dirt Forum for More Information

Author Topic:   solid pull bar,, on 4bar- Zlink
3modump
Member
posted August 10, 2002 12:18 PM
if you got your bars workin good and hookin the car up then put that solid bar on put about 11-12 degrees of pinion angle in it and hold on because it's going to hook it up even more!!


3modump
Member
posted August 11, 2002 12:17 AM
Just put the same angle in the solid bar that you are currently running the pullbar in. I never made any chassis changes after putting the solid bar on my car


jreep
Member
posted August 14, 2002 09:01 PM
i am currently running a four bar with a solid pull bar. we started out with it at about 20 deg but it would lift whole car straight up.i have recently flattened the bar out and it works great. i did go to a 90/10 because the car would set down very hard.


tls88mod
Member
posted August 14, 2002 09:08 PM
Is your mounting point on the rearend ahead or behind the center of the housing?