Visit The Dirt Forum for More Information

Author Topic:   ROLLER BEARING COIL ELIMENATORS
motorsport 18
Member
posted July 01, 2002 04:11 PM
HAS ANY ONE USED THESE YET ARE THEY WORTH THE MONEY I SEEN THEY RUN AROUND150 TO 130


mod4
Member
posted July 01, 2002 07:05 PM
I bought those style from D&M Performance. When they first arrived, I was like "what the heck" - they weren't any more or less free then the cheaper ones. The difference is after 12 nights, they are STILL perfectly free. When I was running the cheaper ones I had to clean them every 4 nights (at least) or they would bind - with these I wipe the shafts down, blow them out with air and am good to go. Thumbs up from me.


2nd2none
Member
posted July 01, 2002 07:42 PM
roller bearing with a grease zirt or a plastic bushing with anti-seize. Well worth the money on the bearings.


Racer X
Member
posted July 21, 2002 09:10 PM
Does anybody know D&M's website? I have looked every where and can't find it.


dirtracer14
Member
posted July 22, 2002 06:38 PM
They dont have a site! I can dig up the # for ya?

1-800-233-0571 Order line
1-806-935-2998 Fax line
1-806-935-2448 Tech line

[This message has been edited by dirtracer14 (edited July 22, 2002).]

Racer X
Member
posted July 22, 2002 09:35 PM
Our car was really loose and could not get bite off the corner. We have been working on the car all year it's slowly getting better.Usually if we are tight off we just add a 1/2 spacer on the rr or adjust the air pressure.