Visit The Dirt Forum for More Information

Author Topic:   pulley line up probelms please help !!!!!!
brownstone
Member
posted May 29, 2002 08:55 PM
Brownstone I had a problem with a pump one time. I had to put a socket over the shaft and push the plate where the pulley mounts back a little.Also you may make sure your balancer is up all the way.


devil wrench
Member
posted May 29, 2002 09:11 PM
How far off are they? Sounds to me like the balancer is on the crank too far. (don't ask me how!!) Keep us posted.

[This message has been edited by devil wrench (edited May 29, 2002).]

brownstone
Member
posted May 29, 2002 09:21 PM
I think the Corvette pumps are a little longer than a short pump, but shorter than a long pump. My Speedway catalog shows the short pump to be 5 7/8" from block mount to pulley side of plate, and 7 1/4" for the long.
What's the one you have measure?
Ken


brownstone
Member
posted May 30, 2002 01:29 PM
thanks for all the help I figured it out. I went to the Stewart water pump webpage and discovered that the pre 69 gm pumps are a little shorter I bought one of those and evrything now lines up thanks for all the help


Back to the Archives