Visit The Dirt Forum for More Information

Author Topic:   sidebite
Brooklyn
Member
posted May 28, 2002 08:05 PM
for sidebite you could soften rt side springs and lower the panhard at the pinion,i assume it's chassis mtd at the left also raise your center of mass heigth if possible. these things will help in any combination. gl jl


LITTLEMAN
Member
posted May 28, 2002 10:20 PM
I'd soften the right front(decrease spring rate by 50 lbs.)lets the car roll more onto the right side tires, and stiffen the left rear(increase spring rate by 25 lbs.mount 50 lbs.above the right rear tire and just behind it if you can.move the right rear tire in for dry this will help the weight of the chassis to be more over the tire and create more sidebite.If the car is to tight on entry after you make these changes, put some more crossweight in the chassis by using the weight jacks or slider adjusters,this will loosen the entry and tighten your exit.hope these suggestions help good luck,littleman

[This message has been edited by LITTLEMAN (edited May 28, 2002).]

dirtbuster
Member
posted May 29, 2002 09:26 AM
lower the panhard bar on both ends and add weight as high in the chassis as you can. this will make the car roll over harder on the right rear and help stick it to the ground.


Back to the Archives