Visit The Dirt Forum for More Information

Author Topic:   front springs
2nd2none
Member
posted May 02, 2002 03:20 AM
Im curious, so far i've been running 750 LF, 850 RF springs on my car, car worked pretty good other than a throttle push when track is heavy/tacky, my chassis builder says to run 650 LF, 750 RF on it, if i change the front springs and keep everything else the same will it loosen the car up or tighten it?

[This message has been edited by 2nd2none (edited May 02, 2002).]

Gene
Member
posted May 02, 2002 04:48 AM
Should allow more weight to go forward going in, and less to go aft comming out. This should make it loose.


wfoondirt
Member
posted May 02, 2002 10:16 AM
Will loosen car in general, most noticable on entry and mid corner


autoshop
Member
posted May 02, 2002 10:17 AM
I'm not so sure about that. Heavier springs might limit the amount of weight transfering because it would begin to rebound before the weight transfer was complete. So, I'm not sure if it's the amount of weight transfered or the length of time it takes it to transfer that weight.


modracer817
Member
posted May 03, 2002 04:20 PM
i dont know about softer, i switched to 1000-900 on the front and have had great sucess because it has allowed me to free up the back of the car, really i dont know how to explain it but the car feels more driveable and still hooks up well was leading in points until car was totaled.


bbracer17
Member
posted May 03, 2002 11:59 PM
Noody can really help just by knowing what front springs are in the car, but never rule out swapping the springs side to side. I sometimes do this, in fact that is how my car is right now.


lightning85
Member
posted May 27, 2002 02:58 AM
explain this to me me please ? you say stiffer lf spring than the rf


bbracer17
Member
posted May 27, 2002 06:38 PM
Lightening, on slower slicker tracks when I can't get the car to turn in or pushes real bad in the apex I run the softer spring on the right front.


George Gilliland
Member
posted May 27, 2002 08:21 PM
The first issue with the front springs is are the front corners frequently bottomed out. I try to run the softest that I can without bottoming.


Back to the Archives