Visit The Dirt Forum for More Information

Author Topic:   Ram Assault Weapon & Throwout
powercar821111
Member
posted April 25, 2002 12:19 PM
I have just put my engine and tranny together and don't have it in the car yet. I have an Assault weapon clutch and the Ram Throwout Bearing (round face). I have ******* the bearing out of the casing as far as it will go, and can only get it to about 1/4 to 1/2 inch of the clutch fingers. Just for setup, about how far away should the bearing face be away. Remember, this is just a starting point, I will adjust it later. Thanx for any info!


Back to the Archives