posted April 11, 2002 10:43 PM
I Just had a funny idea . What would happen if i were to install Spring loaded or rubber biscuit pullbar off the top off the rear housing and mounted it to the lift bar, Would just slow down the whole process or what would happen? Anyone ever try this? It would be easy to do just make lower part of lift bar and install swedge tube with heims on top of housing and on lift bar? Any Ideas or just plain dumb?
posted April 12, 2002 02:39 PM
It would be better to use one or the other and not both together.
posted April 13, 2002 10:47 PM
If you mounted the "pull bar" from the rear end to the "lift bar" what good would it do? I you mount the pull bar back to the frame and use the lift with just the chain mount it will work. Go look at www.bobpierceracecars.com I think they have a picture of this set up. ltr good luck spde
posted April 14, 2002 04:38 PM
If you mount the pull bar from the top of the rearend to the lift bar, it wont do anything.