Visit The Dirt Forum for More Information

Author Topic:   lower a arms
HOTWIRE
Member
posted March 27, 2002 08:44 PM
I will have to assume you have a small metric clip on your car. Because you unse the Nova lower A-frmaes.....

The differance between the older rear steer Nova and the Small metric A-frames is this

The Nova make them about 2 inches wider and moves the lower ball joint forward about the same 2 inches............this helps get rear percent........because most places have a rule about rear end to back of engine block being 72 inches.........The nova lowers move the wheels forward because the rules don't allow for moving the engine farther back..

And the rules are normally 108 minumum wheel base........the Nova lowers lengthen the wheel base about 2 inches.......so you end up with a 110 inch wheel base....and about 3-4 percent MORE rear than if you used the stock metric lowers...........

HOTWIRE
Member
posted March 28, 2002 09:29 PM
What year Novas have these lower control arms? Do you swap sides when you use these? Thanks!

------------------
Thanks, Rob


awkwardjeff
Member
posted March 30, 2002 12:34 AM
67-69 Camaro......along with the 68-72 Nova
These were the same lowers, fit the Small metric front.......the front mount will need a little shim......About a 1/2 inch shim, The Nova/Camaro mount is a little narrow but with a small shim fit PERFECT.......

These are the same Wide front package you get from Flexy...........along with a Iroc drag link if you order the WHOLE PACKAGE...

You will also need to swap them side for side......put the Camaro/Nova left side on the right side of your metric, and right side on left........Camaro/Nova were rear steer...........metrics are front steer....You can't fit them on backwards...nothing would line up.....but if you tried to keep them correct side for side you may need to ask this question.....

So for a guy doing this for the first time I will try and give as much information as I can.......

These Nova lowers help rear percent, But the mess up the steering geometry at the same time..........if you can move the idler and steering box forward to keep the angles of the tie-rods about the smae as they are now.

If you don't move the stuff forward the angles of the tie-rods will create goofy ackerman, and bumpsteer numbers......

Racing is about trade offs.........which end of the car do you want to work??????


Jeff

[This message has been edited by awkwardjeff (edited March 30, 2002).]

2wildcrewguy
Member
posted May 05, 2002 09:54 PM
Where can I buy lower a-arms of the Nova-Camero variety? Is there a source other than junk yards? Is anyone reproducing them? Thanks.


CUSTOMPERFORMANCE
Member
posted May 06, 2002 08:53 PM
To my knowledge nobody is remaking the nova lower a arms . i have a few sets i may consider selling.


Back to the Archives