Visit The Dirt Forum for More Information

Author Topic:   J-bar angle
2nd2none
Member
posted December 02, 2001 08:52 PM
I was wandering what a good starting angle for a j-bar is, how far from floor to heim end on pinion side, how far to floor to heim end on chassis side?


2nd2none
Member
posted December 02, 2001 08:56 PM
last year i had it set 17" off floor on chassis side, 8 1/2" off floor on pinion side, the car wouldnt turn like this, had to lower the chassis side (push rearend to the right) so far the driveshaft yoke would hit the j-bar and gouged it


2 fast 4 you
Member
posted February 07, 2002 06:59 PM
the proper angle for a j-bar is in the trash
runn a short panhard bar then you chasis will hick-up


dirtracr
Member
posted February 07, 2002 08:30 PM
i run the short bar center at the pinion and
about 5 inches of rack
some note i chased a problem for a month also the poblem was it was hiking up so much it would hit the under slug and it was unloading the left rear on exit. i had to notch the under slug. good luck


dirtracr
Member
posted February 08, 2002 08:26 PM
dirtracr Why don't you try puting the shock upside down? or maybe, find a way to put a spacer in the spring to lift it up 2 inches from the floor? Never tried it, but I believe it would produce similar effects, I have no idea if it's even possible. Just another dumb idea from a blond.
From my experience you never want the J-BAR above the pinion and you don't want extreme angle either way.


neverenoughbrew
Member
posted February 13, 2002 06:44 PM
No such answer to this question. CGH, springs, setup, offsets, blah, blah, blah, What you have to do is find enough angle and height along with the total set up, that allows enough sidebite to stick it, without compromising forward bite, being able to get it in the corner, through the corner, off the corner. There is not one single answer, or any car or driving style alike.