Visit The Dirt Forum for More Information

Author Topic:   leafs to 2 link
cowboy85
Member
posted October 03, 2001 02:49 PM
I have a multi leaf chassis that I have been thinking about changing to 2 link or swing arm. Has anyone ever tried this? Is it worth the trouble? What do I need to change in order to make this work? Any help is appreciated.

Thanks,
Matt


bogged
Member
posted October 03, 2001 08:19 PM
the only thing that would be needed are a couple of radius rods and a method of mounting a pan-hard bar. depending on the method of attaching the rear springs (weight jacks or sliders) there is not that much fabricating to be done if the car is underslung.


cowboy85
Member
posted October 03, 2001 09:52 PM
That is where I think I will have the most problems with, it is an overslung chassis.


Matt


MOD RACER#93
Member
posted October 03, 2001 11:14 PM
I did this same exact thing to my 98 Shaw car that i have, except that the J-bar moutn was already there for me. just took off the leaf blocks from under the rearend and bolted up some two link mounts.

Good Luck.

Strokin3
Member
posted October 04, 2001 07:01 PM
It will definitely be worth the trouble. If you do the work youself rather than let someone else do it for you, you will understand your suspension a lot better. Put plenty of holes for the forward trailing arm mounts to get at least 20 degrees uphill and make sure you will be able to get about the same angle downhill for your 3rd link. I converted from leafs to 3 link this winter with the help of the Dirt Forum and Jerry Guest and our car became super fast.

------------------
Artie Perilloux


cowboy85
Member
posted October 04, 2001 09:25 PM
Thanks for the help, it sounds like it will be fairly easy. All I need to figure out now is how to build the underslung rear portion. Any advice?

Thanks again,

Matt

Strokin3
Member
posted October 05, 2001 02:45 PM
Cowboy, you don't necessarily have to run underslung if you dont want to. It makes it easier to mount the chassis side mount for the panhard bar but it can be done without being underslung.


Back to the Archives