Visit The Dirt Forum for More Information

Author Topic:   U-JOINTS HELP!
jklostermann
Member
posted May 20, 2001 08:45 PM
Since the start of the year I have lost 3 drive shafts do to u-joints heating up and melting down! It is happening on the rearend side where the caps bolt to the pinion. Any advice would be helpful.


MOD#11
unregistered
posted May 20, 2001 08:52 PM           
Too much pinion angle will do it every time.


Gene
Member
posted May 20, 2001 10:42 PM
Too many grunts on the u-bolts dont help either.


bbracer17
Member
posted May 20, 2001 10:48 PM
If they are getting hot it has to be to much torque on the U-bolts. They don't have to be extremely tight.


jklostermann
Member
posted May 21, 2001 08:18 AM
Is there a torque rating I should fallow?


tls88mod
Member
posted May 23, 2001 09:52 PM
Check to make sure your yoke is square where the caps fit. I had the same problem and I replaced the yoke and it fixed it.


Gene
Member
posted May 26, 2001 07:26 PM
Using a typical 1/2" wrench they need to only be good and snug. I've never had them come lose or break. Too tight will deform the caps causing the wear/melting problem. Of course other things may be causing this, so heed all the suggestions you've been givin.


Back to the Archives