Visit The Dirt Forum for More Information

Author Topic:   Left Rear Weight????
start79
Member
posted May 10, 2001 06:51 PM
I thought that by adding left rear weight you would be inducing the car to push. However, I have been told by several folks at the track that they are having to run in "excess of 200 lbs.) to get the car to turn. Why is this?

Thanks.

bbracer17
Member
posted May 10, 2001 09:35 PM
my car is looser under braking with a lot of left rear but is alot tighter when I get back in the gas. I'm not sure how everyone elses is but thats how mine feels.


LITTLEMAN
Member
posted May 11, 2001 07:17 AM
If your car is a swing arm or z-link that the direction I would go,More crossweight thus left rear not more left side weight that will make your car loose on entry.But if you have a 2-link its just the opposite more left side less crossweight,GOOD LUCK


BILLY BOB
Member
posted May 11, 2001 08:09 AM
when alot of lr weight is run, the car will normally be loose going in when you are on the brakes. the car will pivot around the tire with the most traction. of course it is just the opposite when you get back on the gas.


wfoondirt
Member
posted May 11, 2001 09:29 AM
First off, predicting the handling of a car by the weight of one wheel is not the best senario. the are many different combinations of percentages that will give you a heavy left rear. Typically if diagonal is added to make a car turn it is because they are slowing the car mainly with the rear wheels thus more diagonal will loosen the car on entry. generally if left side percentage is increased it tightens entry, but this can only be done by physically moving weight.


Back to the Archives