Visit The Dirt Forum for More Information

Author Topic:   mocking up tanny and engine help?
maniac motors
Member
posted November 29, 2002 09:44 PM
mocking up motor and tranny in my hobby stock
engine placement rule is #3 plug line up with driver baljoint with a square set against head.my questin is what shoud pinion angle and trans angle be with a anglefinder set on back of tailhousing (face of it)i have engine tipped to left a little and am wondering what angle motor should be? help me out so i can weld the mounts permanantly.
thanks in advance for any help.


Flatlander
Member
posted November 30, 2002 12:25 AM
4 degrees down toward the rear measured on top of the driver's side valve cover. #3 @ the ball joint is kinda weird!


maniac motors
Member
posted November 30, 2002 07:55 PM
was told by tech man that the class requires engine to be in there with #3 plug lined up with bj on that side.can you line #1 up with it and still run a stock type fuel pump without cutting crossmember?


tilley88
Member
posted November 30, 2002 09:45 PM
No, it must be cut.


maniac motors
Member
posted December 01, 2002 03:11 PM
thats why they go by #3 plug then because we are not allowed to modify cross member or engine cradle in any way.


Back to the Archives