Visit The Dirt Forum for More Information

Author Topic:   help!!!
keith24kracing
Member
posted October 20, 2002 09:20 PM

i have a 83 monte carlo and i was wondering if anybody could tell me if there is hub/rotor off a ford that will fit the chevy spindle.


jammin
Administrator
posted October 20, 2002 09:41 PM
have to change spindles .....pinto is what we run on our mods.

jammin

Pickel
Member
posted October 20, 2002 09:57 PM
A few years ago I ran Pinto spindles with GM metric rotors. It worked great. Next year I'm going to try Aerostar rotors that way the bolt pattern is the same all around the car.


tilley88
Member
posted October 20, 2002 11:40 PM
Hey Pickel, what bearings did ya use?


outlawstock17
Member
posted October 21, 2002 08:04 AM
a granada rotor will work on a pinto spindle with the pinto bearings and inner seal. the granada rotor is 11" and the aerostar is 10". you can get adapters to fit the pinto spindle with a GM metric caliper. works real nice with the granada rotor, 5 on 4.5".


keith24kracing
Member
posted October 21, 2002 07:42 PM
what about the upper/lower control arms.will they match up with the pinto spindle or would ya have to just change ball joints.i appreciate all the help i can get. thanks!!


jammin
Administrator
posted October 21, 2002 07:50 PM
chevelle lowers will fit pinto spindles, you have to ream the hole out a little to make them fit and get the correct angle for roll center and bumpsteer purposes.

jammin


Back to the Archives