Visit The Dirt Forum for More Information

Author Topic:   a arm bushings
justin
Member
posted October 09, 2002 12:30 PM
I'm going to replace the a arm bushings in my 75 camaro and I'd like a little input on which type to use: the solid steel or poly's.
I've heard the solid steel bushings require a lot of maintenence to make them work properly and if you ever brush the wall w/'em there is no flex and you'll easily bend the a arm. Is this true? What are the advantages and disadvantages of the poly's? Any help would be appreciated. Thanks in advance

Justin

RangeRover
Member
posted October 09, 2002 02:44 PM
While building up my present car I chose steel. I haven't raced it enough to give a real fair assesment yet, but I did whack the wall a few times this weekend (1 time was pretty dang hard with the rf) but I haven't seen or measured any ill effects on the front end since that time.

Although I'm liking the steel so far, I would have to agree with rangerover in using poly since I have such limited running time on steel at this point.

hughes
Member
posted October 10, 2002 11:19 AM
Save some cash an just put them in the front right. Think about it the LF is just along for the ride. Take the two extra ones and put them in your back-up a-arm so if you bounce it off the wall "your ret ta go". Hey maybe I'm just to cheap


redneck racing
Member
posted October 11, 2002 01:08 PM
I run the polys less maintainence and cheaper than steel. I run them in the lower a's and in my rear leaf springs. Eddie


Back to the Archives