Visit The Dirt Forum for More Information

Author Topic:   roll cage?
Eljojo
Member
posted September 25, 2002 03:39 PM
If a guy had access to all the .o95 tubing he needed, how much do you think a fabricator would want to bend him up a cage and install it? I mean 4 pt cage, front loop, rear downbars, install the seat mounts, totally welded out? If ya don't know-take a guess!


outlawstock17
Member
posted September 25, 2002 06:58 PM
i've built quite a few racecars using different sized tubing in different areas of the car. i've never really checked footage, but i think 200'-300' should be plenty. i like to use 1 3/4" for the main cage, drivers door bars and bumpers, 1 1/2" for the kick downs and passenger door bars, 1"x2" square for my floor "X" and 2"x2" square for frames/frame connectors and 1 1/4" and 1" for misc. other bracing. 3/4"x3/4" square for body mounts.


racer17j
Member
posted September 26, 2002 09:37 AM
more than likely around $500-700. most chassis run around 1000-1500 now a days and i would guess 500 of it is the tubing


outlawstock17
Member
posted September 26, 2002 01:19 PM
duh..........that one went right over my head......at first. i agree with racer17j. it's going to cost you at least $500. the cost of the tubing alone should be less than $200 if you know where to get it.


tilley88
Member
posted September 26, 2002 07:55 PM
175-200'


redneck racing
Member
posted September 28, 2002 06:54 PM
Out here the main cage is about $800.00 if you want the seat mount,fuel cell mount, front bay etc your looking at about $1500.00. Eddie


dean_7585
Member
posted October 03, 2002 05:40 PM
We build chassis in my shop in Michigan, and I can build a street/bomber chassis for about 1200.00 depending what you want done.

1 3/4 main cage with 4 door bars and 1 1/2 front and rear bars with X in rear and on frame and kick downs.

dean7585@msn.com

bubba
Member
posted October 03, 2002 06:49 PM
go to stockcarproducts.com
they have complete cages for any car
bought mine there and there already pre-bent
cost $350.00 complete cage
also get the gussets


Flatlander
Member
posted October 04, 2002 10:46 AM
Got the Camaro back from the fabricator on Thursday. Nice four point cage-set waaaaaaay back. Four bars in drivers door, three bars in rt door, one dash bar three rear firewall bars (2 horisontal, one diagonal) one down to subframe from behind driver, one from front post to subframe, two front bars thru firewall to just in front of the A-frames, two rear downbars thru package shelf, one loop @ rear between tail lights. Used 6 1/2 twenty foot sticks of tubing. Furnished 2X3 box tubing to weld in floorboards to mount cage to (rules don't allow subframe connectors) and furnished checkplate to cover package tray and rear firewall. Labor and mat'ls $300.00 I furnished the tubing.
Want a good, safe, inexpensive rollcage?


Back to the Archives