Visit The Dirt Forum for More Information

Author Topic:   handling problems
dirtracers
Member
posted April 12, 2002 09:55 PM
The car is a 76 Monte Carlo that wieghs about 3400 pounds it enters corner tight and exits loose. The car has a 225 lr and a 200 rr the car is like a brick it never gives. Others have stronger springs but still give a little. We run 275 60s on the back and right front and a 235 on left front. The car has plently of motor to help out on straights and will still keep up but every one else gets aroung the corner better


racer17j
Member
posted April 13, 2002 03:32 PM
you could switch your rears around that would loosen you up on entry also air presure might be something to look at what are your front springs?


KWTracer
Member
posted April 14, 2002 10:49 PM
First off, make sure your not botteming anywhere. If you run out of suspension travel, your going to get infinite spring rate. Next, make sure your tight in problem isn't causing your loose off condition. For instance, if your tight in, and you crank the wheel left and get on the gas to make the car turn, its going to snap loose when it does turn.


racer17j
Member
posted April 15, 2002 10:46 AM
your right 95% or the time if you are tight in and you try to make up for it your going to be loose out


driver27
Member
posted April 15, 2002 01:08 PM
Dirtracers, check your private mail. I've sent an attatchment that might help a lot.

Anyone else wants it please let me know machinah@aol.com

[This message has been edited by Machinah (edited April 20, 2002).]

Back to the Archives