Visit The Dirt Forum for More Information

Author Topic:   metric spindles
istock59
Member
posted November 15, 2001 07:08 AM
I have a pair of metric spindles that I need to ream to clean-up the top of the holes (after bending BJs). The Afco catalog lists 2 tapered reamers for the job. Does anybody know which one I need?

I don't want to change the taper, just cut it a little deeper.

Thanks.

dirtracer17
Member
posted November 15, 2001 08:37 AM
I already run the tall upper balljoint for all those reasons. And the reaming is just on a spare pair that are too good to throw away.

I really think it's the 2" per foot taper that I need. But I don't want to spend $100 and be wrong...

Back to the Archives