Visit The Dirt Forum for More Information

Author Topic:   ford 9" help
VIPER000
Member
posted September 07, 2001 09:15 AM
ok hear we go i have been fighting with getting info on ford 9" so i can put it under my firebird. got one out of a 77 bronco but i don't think the springs are going to bolt up because the tubes arn't wide enough.

what is a good 9" to get to put under the car without cutting down?

next point. how much would it cost to get a wide rearend cut down is it something i could do myself. other than the axels and i have been told that you cannot cut down 28 spline axels is this true.

so far i have spent $200 and all i have to show is an extra 3rd member and axels and housing that i can't use.

c21
Member
posted September 07, 2001 10:31 AM
I use a 9 inch from a 75 Grand Marquis. The axels have 5" x 5" bolt pattern and the rear end will be about an inch wider than the front end. I run 3inch offsets on the front and 4 inch on the back to square the car. You'll have to buys leaf perches and weld them on, but I've had good luck with this rearend so far. I put disc brakes on mine, if you do this, the axels will have to be trimmed a little for the rotors. I use "hats", and if you do this, you'll have to cut alot of the axel flange away.


dirtracer17
Member
posted September 07, 2001 09:55 PM
Call Danny Miller rear gears in kirkwood,mo. You can get exactly what you want and not be out any more than you would be if you found one in a junkyard and built it the way you want. and if you need axles,you just call.


Back to the Archives