Visit The Dirt Forum for More Information

Author Topic:   BALL JOINTS???
fast_crew
Member
posted July 09, 2000 08:28 PM
I was wondering if there is a stock appearing upper or lower ball joint to raise the rollcenter on a 86 metric body. And do you have to reem the spindles?? Any help would be appreciated.


thanks Josh K.


StevePhillipsJr
Member
posted July 12, 2000 11:00 PM
Afco makes an extended ball joint to raise your stock roll centers. I don't have the part numbers with me right now. And I believe there is some reaming required to seat the ball joint into the spindle far enough. Hope this helps.


FIB-BIF
Member
posted July 27, 2000 11:16 PM
FOR THE LOWER THE AFCO# IS 20038-1, YOU WILL HAVE TO WELD IT IN PLACE AND HAVE TO REAM IT WITH A 1 1/2" / ' TAPERED REAMER. THEY DON'T MAKE A TALL UPPER TO FIT STOCK UPPERS! WISH THAT THEY DID! YOU CAN WELD ON AN APPER A PLATE , AND USE A 20038-1 UPPER TALL ONE.

[This message has been edited by FIB-BIF (edited 07-27-2000).]

Back to the Archives