Visit The Dirt Forum for More Information

Author Topic:   Starter/Block fixture
YAR
Member
posted June 17, 2002 07:54 PM
I have a 350 with stager bolt starter bolts. and they do make a stager bolt nose cone for a starter.


chief4car
Member
posted June 17, 2002 08:47 PM
You can use a starter with the right bolt pattern as your template. Just put it on with the one bolt and square it up to mark or drill the other bolt. Piece of cake.

Jim
Cleaver Racing Inc.


racer17j
Member
posted June 18, 2002 02:26 AM
i would find a different starter before i started to drill holes in my block if i rember right you can get mini starters with either bolt patern i'm asuming thats what you have if not just do like 3d suggested get a old 350 starter and switch the heads on them


smayo964
Member
posted June 18, 2002 04:07 PM
You can get a standard SB400 starter with offset holes. Run them on all my SB350 engines. Have about 3-4 of them laying in the garage.


Monster
Member
posted June 18, 2002 04:52 PM
I drill the hole as standard procedure on all blocks like this. It's a whole lot easier to do on a stand than on your back, thrashing to make a race.


YAR
Member
posted June 18, 2002 08:42 PM
I use a Tilton superstarter, so I can't switch the nose like on a stock starter. Sorry, I should have stated that in the beginning.


powerglides
Member
posted June 19, 2002 06:22 AM
Go to the auto parts store and smoose the parts guy to keep looking at starters until you find one with the dual patern. take it home use it as a drill guide then take it back


1195
Member
posted June 19, 2002 11:20 AM
Goodson has a drill jig in their catalog www.goodson.com


Back to the Archives