Visit The Dirt Forum for More Information

Author Topic:   float adj.
c&s44
Member
posted April 28, 2002 08:32 PM
I,m not sure about the best way to set the float on a holly 750 D.P. Ihave to replace the back bowl due to stripped adj. for float Thanks


KWTracer
Member
posted April 29, 2002 10:34 PM
Contact Earl. Parkercarburetion.com


sdhnc29
Member
posted April 30, 2002 11:11 PM
Turn the bowl upside down , and adjust the float so it is level with the top of the bowl .


redneck bubbas racing
Member
posted May 01, 2002 01:15 PM
First off make sure the motor is cool and you have a fire ext. handy. Start the motor and remove the plug in the side of the fuel bowl. Loosen the nut on the adjuster. If fuel is running out of the hole tighten down on the center with a screwdriver. If none is coming out loosen up on the center adjuster. You will want the fuel to just barely trickle out of the hole.


Wheels47
Member
posted May 19, 2002 09:40 AM
Redneck is correct--- we set ours so you have to rock the car just a little bit to get the fuel to spill out the hole in the fuel bowl. while the car is running you will hear the motor speed up or idle down as you adjust the float ***** .. good luck-- Wheels


Wheels47
Member
posted May 19, 2002 09:42 AM
hmmm that should read float s c r e w - but got blocked out


Back to the Archives