Visit The Dirt Forum for More Information

Author Topic:   advancing the camshaft?
LUBEGUY07
Member
posted April 28, 2002 09:39 AM
are car is very fast at the last part of the straight but kind of doggy out of the corner, and the tires are not spinning so its not that, do u think advacing the cam 4 degs would help or not? the only thing we havent changed on the motor is the cam. The timming is ok its set a 38 degs. or should we just change the cam? thanks


ford5
Member
posted April 28, 2002 10:29 AM
yes lubeguy, advancing the cam will lower the powerband,but in some cases you could be creating piston to valve clearance problems


SLEEPY GOMEZ
Member
posted April 28, 2002 12:30 PM
Hey lubeguy, ford5 is right on both counts. But did you degree the cam on installation? Do you have a 3 or more position key timing chain assembly. The multiple key sprockets can fool you sometimes. The cam could be retarded instead of being advanced. Most all cams are ground so the zero/zero timing marks on the sprockets are really 4 degrees advanced. So if a 3 key sprocket is in the retard position the cam might be at true zero.


marty
Member
posted April 28, 2002 04:37 PM
Your cam could be a little too wild for what you are using it for. If the lobe seperation is too big (maybe 112 degrees) then you might need to go down to 108 degrees to help out of the turns (but its always a compromise). Maybe reducing the the rocker ratio would have a similar effect but you can't physicaly alter the lobe seperation of the cam.


4barrel
Member
posted April 28, 2002 06:06 PM
ok thanks for the info guys thease are the specs for my cam 114 lobe center 465intake lift 488 exhaust lift advertised duration 282 intake and 292 exshaust its a hydralic cam and the timming chain is straight up on zero. most guys i race against have cams with 108 lobe center with higher lift cams to. Should i just buy a new cam? any advice on that, i have used isky cams before seemed to work good but rough idle and its sapose to sound stock. and we didnt degree the cam we put it in,a freind used the same cam a few years ago and he won alot but things have changed since then people run bigger motors and have good gears now. any advice would be apprciated thanks again



Flatlander
Member
posted April 28, 2002 09:52 PM
Since you say you didn't degree the cam, you might want to install it properly and give it another chance before you buy somthing else. You need to degree the cam properly before advancing or retarding.


marty
Member
posted April 30, 2002 01:25 PM
What rev range are you running in? The cam you have in sounds like it would work best in the 4500-7500 rpm range.


LUBEGUY07
Member
posted May 01, 2002 09:59 PM
ok thanks for the info guys i think ill try to degree the cam and see how far off it is, hopefully its that so i dont have to spend more money. thanks again



Back to the Archives