Visit The Dirt Forum for More Information

Author Topic:   Cam Bearings
Rod65
Member
posted April 01, 2002 08:12 AM
leave the crank out & drive them in until you can see through the oil holes from the crank journals into the cam journals


ryan
Member
posted April 02, 2002 12:56 AM
My machine shop said to put the bearings on the front and rear straight up and the rest at 2 o'clock


4barrel
Member
posted April 02, 2002 07:34 PM
It wont make a difference as there is a slot cut in the block on a sbc the General puts them in at as follows panrail at 12:00. #5 oil hole at 6:00. #4-3-2 oil hole at 10:00 .#1 oil holes at 6:00 and 3:00.


Back to the Archives