Visit The Dirt Forum for More Information

Author Topic:   CHEVY HEAD 041
42
Member
posted February 23, 2002 10:34 AM
Leave the floor alone !!!!!! This is a common mistake for a lot of people . Do not touch the floor of the intake or exhaust port ! Instead , you should concentrate on the roof of the port , the bowl , and the adjacent head bolt hole side of the port if your going to do anything . As for pockets , you can open them up a little , but be sure to maintain a venturi ! Another common mistake is to just port straight down off the seat , and this looses flow . You can lay back the short side radius a little , and pick up some air . But not too far , or you'll lose low lift flow , and perhaps find water . The biggest gain you will find , will come from the adjacent intake wall's . You can port right on through the head bolt hole between the two intake port's , and then sleeve the head bolt hole . In the pocket area and the head bolt side of the runner is where you'll find the most gain's for your effort .

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


42
Member
posted February 25, 2002 06:34 PM
We use bronze sleeve's for the head bolt holes . I'll have to ask my dad where he gets them , but I'll post his source for you on this board . As for sealant , we use good old red Loctite . We used to use the green Loctite with a priming agent applied first , but found it difficult to install the sleeve's fast enough before the Loctite went off .

------------------
Hendren Racing Engines
Rutherfordton , NC
(828)286-0780


42
Member
posted February 25, 2002 10:35 PM
Hey 42,
I blew up a perfectly good (well, maybe not) motor with a set of 041's on it. I lost one head and still have the other, (valve) I sure would like to have another head to go with the one I have. Motor runs better with 2 heads on it yaknow... LOL. Anyway, do you know where I can secure another 041 that is missing a partner?


42
Member
posted March 16, 2002 09:02 AM
RATS!! thanks anyway man, let me know if you run across anything.


ryan
Member
posted March 17, 2002 06:50 PM
Is this what your looking for
#041 CLOSED CHAMBER HEAD, 1.94-1.5 VALVES, UNTOUCHED BARE CASTING, PRESSURE CHECKED - $95
www.mrracingequipment.com/usedparts.html
click on the heads icon on top



Back to the Archives