Visit The Dirt Forum for More Information

Author Topic:   Camamshafts
posted December 08, 2001 02:54 PM
I have a cam card that The measurment are taken at .020 Tappet hieght. How do I convert it so the measurements are at .050 tappet hieght? This is probably simple to do but I'm not too good at math.

posted December 08, 2001 03:55 PM
I assume you are talking about the duration measurment. I don't beleive there is a magic formula to convert from .020 to .050 because the ramps on the cams can be different. If you have the cam card with the brand just call the cam manufacturer and they can give you every measurement you need.

posted December 12, 2001 08:23 PM
Call Charles at Camcraft and tell him The Dirt Forum sent ya.

Charles can tell you anything you need to know and knows his stuff. After you talk to him, you will never buy another over the counter camshaft.

Back to the Archives