Visit The Dirt Forum for More Information

Author Topic:   please help bert tranny trouble
fridge
Member
posted June 18, 2001 09:58 PM
ok, tonight i went to put my bert tranny in my car for the first time. It is new, i took it out of the box and i went to put it up into the bellhousing, i wanted to line it up with the couple so i took a ***** driver and pulled the top shifter out the whole way cause i thought it would put it in gear, then i could turn the tail shaft and it would turn the shaft up by the couple, but when i turned the tail shaft the front shaft didn't turn, so i switch the shifter tierod back in between the whole way in and the whole way out(not sure whaty gear) and it still didn't turn everything, then i pushed it the whole way in and pulled out the bottom one and it sorta made a light gear grind noise but the noise wasn't bad.but still didn't turn the front shaft, i also tried turning the front shaft cause i thought it would turn the back but it didn't, i did not have any fluid in it or anything hooked up to it, my question is, is the is normal and will it go into gear when i hook up everything or am i not getting it into gear right. PLEASE HELP
thanks in advance


9w RACN
Member
posted June 18, 2001 10:33 PM
YOU MIGHT HAVE TO SPIN THE OUTPUT SHAFT AS YOU PUT IN GEAR TO GET THE TEETH TO LINE UP. REMEMBER IT DOESN'T HAVE SYNCRONIZERS IN IT.



Back to the Archives