Visit The Dirt Forum for More Information

Author Topic:   Bearing Clearances
nvracer
Member
posted March 21, 2001 08:03 PM
On a sbc, on the main & rod bearing clearances what are the acceptable tolerances to you when you are putting the motor together. I have heard many different numbers. Thanks


goose
Member
posted March 25, 2001 08:10 PM
the bearing clearances depend on what the motor will be used for. street, 1/4 mile, or circle track. r.p.m and torque determine clearances. please explain a little more about your engine.
quote:
Originally posted by nvracer:
On a sbc, on the main & rod bearing clearances what are the acceptable tolerances to you when you are putting the motor together. I have heard many different numbers. Thanks



Red Dog
Member
posted April 10, 2001 10:23 PM
We run all our circle track motors at .0025 (mains and rods with 50w oil) and never had any problems. Don't use plastigage to check clearances, it is not accurate.


Back to the Archives