Visit The Dirt Forum for More Information

Author Topic:   Q-jet tips
dragonfly
Member
posted September 11, 2002 06:53 PM
we aint supposed to use holley carbs or elderbrock and so on ., just the studdering Q-jet does anyone have a few good tips to make the q-jet perform better ? thanks


KPLugnut
Member
posted September 11, 2002 07:47 PM
Well, for starters, to give you a lot of good info, I'd say pick up a copy of Doug Roe's book called "Rochester Carburetors".
Amazon.com would have it.
I'm not a salesman of his either, but it's
a good baseline and source of beginner's info.

Outside of that, all I can say without writing a book longer than War & Peace is that we can fix your carb for a little bit of nothing and you'll be amazed at the difference.
Some of the things we do are:
Change primary fuel metering circuits
Tune and time throttle opening points
Alter main circuits heavily and install
custom made main feed tubes and main bleeds.
De-burr and re-plate entire internals and externals
Enlarge pump well and custom build new pump
and change pump timing and geometry.
Close off all unneeded vacuum ports.
Install correct primary and secondary rods
Alter power piston
Install new sec. air valve spring and sec. cam
.....anyway, you get the idea...we spend some hours "tinkering", that's for sure.

Kinetic Performance

Merlin
Member
posted September 11, 2002 11:27 PM
so kp how much fer some lil' tinkerin' like that, i just might let ya tinker with mine if the price is right!!


KPLugnut
Member
posted September 12, 2002 07:18 AM
You have PM, Outlaw....thanks for the interest.

KPLugnut

rico 08
Member
posted September 17, 2002 12:43 PM
don't take the big choke off the rear barrels that's what draws in the fuel when they open and you will have one big stumble or flat spot if you want them to open quicker on the pass side there's an allen ***** under the top hold the spring adjustment inside where the butterflies swivel and loosen the allen back it off slightly and tighten the allen back you can play with this to get it to open sooner or later also the accelerator pump well could use a longer slot to help it get more fuel in the corner


Back to the Archives