Visit The Dirt Forum for More Information

Author Topic:   dowel rod removal
justin
Member
posted May 01, 2002 03:22 PM
I'm running rear motor mounts this year so I'm going to have to put longer dowel rods in the block to compensate for the mount thickness. What's the easiest way to remove and install these. Would a hammer and punch work or is there an easier way. I wanted to ask first before I tear anything up. Thanks in advance.

Justin

RACER35
Member
posted May 01, 2002 08:22 PM
A HAMMER AND A DRIFT SHOULD WORK FINE! NEW DOWEL PINS CAN BE MADE OUT OF A 5/8 BOLT.(USE THE SHANK SECTION WHERE THERE ARE NO THREADS)


Back to the Archives