Visit The Dirt Forum for More Information

Author Topic:   Ball Joint Replacement
killermiller
Member
posted March 13, 2002 05:50 PM
Ok I am new to racing, I have a 79 regal and want to put in new ball joints. Is there any secrets to replacing them? It appears they are riveted right to the a-arm. If they are how do you get the old ones off? Thanks


techmaster35
Member
posted March 13, 2002 07:10 PM
use a grinder to cut the rivet heads off or drill them out. nothin secret to installing them but if you want some strong ones install chrysler scr*ew in ball joints. they are trick to install but strong as heck.

[This message has been edited by techmaster35 (edited March 13, 2002).]

redneck bubbas racing
Member
posted March 14, 2002 08:50 PM
Definetly easier to drill them. I just did two arms and decided to try both ways. Just a note- I have always grinded them off. Guess what? Never again, from now on its drill time. It took about 3 minutes to drill, 45 when I grinded them off.


juni
Member
posted March 15, 2002 07:30 AM
REDNECK BUBBA RACING
If you plug that grinder in, then push the button, you'll find that those rivit heads will be ground off in a minute. 45 minutes of shakin' that grinder around is pretty hard work aint it!?!


blanep
Member
posted March 17, 2002 08:33 PM
Lmao


Back to the Archives