Visit The Dirt Forum for More Information

Author Topic:   Chevy 350 power stearing pump / pulley set up?
PB II
Member
posted August 02, 2001 12:46 PM
What type of power stearing pump set up should be used in a monte carlo with a chevy 350? I am almost ready to put the motor in, I just need to figure out the pully set up. Any suggestions or comments; does it even matter?


Racer77
Member
posted August 02, 2001 01:49 PM
i use the power steering pump from the 305 and stock pulleys from the 350


redneck bubbas racing
Member
posted August 12, 2001 12:17 AM
Another tip regarding power steering. Find an old dead pump and cut the neck off of it. Attatch this to the pump on your car with a piece of hose. Whenever you put the fluid in fill it to the top of the bottom neck. This should just barley touch the didpstick. Also, the nut on the back should be drilled out some. The nut or fitting if you'd rather goes into the high pressure line. Start out a little bit bigger than stock and slowly work up. This will make the steering feel looser but it will help keep the pump from over heating. Kenneth


PB II
Member
posted August 14, 2001 10:22 AM
thank you for the help!


Back to the Archives