Visit The Dirt Forum for More Information

Author Topic:   Changing harris spindles
Reign
Member
posted December 19, 2000 09:51 PM
I have been running older style impala spindles on my 93 Harris the spindles are I think off 72 impala I wanted to go to the newer gm spindles off 82 and up I was wondering if I have to change the upper a arms to get the right geometry there Chevelle lower a frames any help would be appreciated
the spindles I want to use have the number 2 on the back side if you know which ones I mean


CUSTOMPERFORMANCE
Member
posted December 20, 2000 03:24 AM
ITS A BOLT ON SWAP. YOU WONT HAVE TO CHANGE ANYTHING. USE THE 12 INCH 82 AND LATER SPINDLES WITH THE NUMBER 2 CAST IN SPINDLE. JUST MARK YOUR BALLJOINTS WHERE YOUR OLD SPINDLES ARE REAMED AT AND THEN REAM THE NEW SPINDLES THE SAME. USE THE ROTOR THAT COMES WITH THE NUMBER 2 SPINDLES AS THE ROTOR DOES NOT INTERCHANGE BETWEEN THE TWO DUE TO DIFFERENCE IN THICKNESS. I THINK THE OFFSET IS A LITTLE DIFFERENCE AND YOU WILL WANT TO RUN 1/2 INCH SPACERS ON BOTH FRONT ROTORS IF NOT ALREADY DOING SO.


Back to the Archives