Visit The Dirt Forum for More Information

Author Topic:   Motorplate for metric
RACEINMUD
Dirt Freak

Total posts: 327
posted December 07, 2005 08:35 AM  
Anyone know if there is a company that makes a mid motorplate for a metric chassis? I saw one on a terminator car that fit between the frame rails and followed the motor contour. Any ideas? Thanks, Race

Raceman17
Dirt Maniac

Total posts: 179
posted December 07, 2005 10:32 AM  
Get me the deminsions and I can make you one on a water jet.
Later

istock59
Dirt Forum Champ
Total posts: 509
posted December 07, 2005 11:14 AM  
I believe the one you're talking about is made by TCI. Has a flexplate shield built in.

ALCOHOL
Dirt Full Roller

Total posts: 48
posted December 11, 2005 03:17 PM  
We use the plate for Dirtworks mods. It has a 5/8" offset. We use Schoenfeld stock chassis headers and this works fine.

  

Back to the Archives