Visit The Dirt Forum for More Information

Author Topic:   4 link mounts on 9"
Malibu Man
Dirt Roller

Total posts: 17
posted October 15, 2005 11:50 AM  
Anyone got any trick ways to put the 4 link mounts on my 9".

By the rules no adj, holes.
both sides need to be same distance below the axle tube.

Wondering if I should lead the rr or lr at static setting?

What kind of pinion angle should I set if for?

cars a full size chevelle not a metric

thanks in advance.

[This message has been edited by Malibu Man (edited October 15, 2005).]

racer17j
Dirt Forum Champ
Total posts: 5390
posted October 17, 2005 07:22 PM  
Ive got a tape measure and can put my own mounts on then re straighten my own rearend.

I was hoping someone would have tried and be willing to share if they lead or trail their rr.

Ive decided Ill do my mounts straight up and adjust the lead or trail with the trailing arm holes and washers..

17j, have you seen any jigs different then the ones Ive seen??? simply a rear frame section with trail arms on it, and two saddles you set the rearend in. then center it and set pinion angle and weld on the mounts.
Also do you know ANYONE who does rearends for large gm cars like mine?

sideways
Dirt Forum Champ
Total posts: 715
posted October 22, 2005 07:01 PM  
I prefer soft bushings in the left lower so on the gas it leads and off it trails.

racer17j
Dirt Forum Champ
Total posts: 5390
posted October 23, 2005 08:31 AM  
the ones we had bolt to the front of the housing then you hang your mounts off it. where are you from might be able to suggest somebody if your in or near iowa. the guy i used to help has cancer and has had to sell off all his equpit or i could do it for you

    

Back to the Archives