posted July 27, 2005 08:54 AM
Ok guys which is the best way to straighten a front kickup? Right front is bent up about 5 degrees right at the kickup bend. Do I cut the bars off (running from kickup to rear frame) and bend it back down and reweld, they are pushed back 1/2". Or do I cut a slice right at kickup from bottom up to top and leave bars on and bend it and reweld slit? I have done frame work before but am always looking for an better easier way. Horn is cut away now.
tin cup Dirt Full Roller
Total posts: 40
posted July 27, 2005 02:53 PM
Don't cut anything! It bent as one, so bend it back as one. We did the same thing. I had it put on a frame machine and bent it back in place with a little extra bend at the end. It will flex back a little bit. I had them put a some extra bend in it. My driver like it. Said it handled a better. If it happens again, i'll do it again.