Visit The Dirt Forum for More Information

Author Topic:   Triple Disc Problems Need Help
BIGDADDYBOZ
Dirt Freak

Total posts: 466
posted April 25, 2005 10:54 PM  
I put my Triple Disc in and measured clearance for the throwout and it's almost a 1/4 of a inch from being flush with trans installed. I have a Howe Throw out bearing and a Quarter Master triple Disc. Anyone ever had this Prob? thanks

jesup76
Dirt Roller

Total posts: 18
posted April 25, 2005 11:42 PM  
If your throughout bearing is like mine it sets on two studs that come out of the trans. All I did was back the nuts that were on the studs in or out to get the right clearance
Blaine

BIGDADDYBOZ
Dirt Freak

Total posts: 466
posted April 26, 2005 08:46 AM  
My throw out bearing doesn't even touch the nuts on the studs it bottoms out on the snout before hitting the nuts. The throw out is tight against the clutch before the tranny is all the way in. Thanks

[This message has been edited by BIGDADDYBOZ (edited April 26, 2005).]

vosevichs
Dirt Forum Racer

Total posts: 78
posted April 26, 2005 09:53 AM  
Make sure you have the right release bearing. There are 2 types. 1 for mulit disc clutches and 1 for single disc clutches. Multi disc release bearings are shorter

------------------
Scott Vosevich
RDBoyz Racing

BIGDADDYBOZ
Dirt Freak

Total posts: 466
posted April 26, 2005 09:59 AM  
It's the Howe for Triple Discs. Are there different front snouts for 3 speed Saginaws Maybe? Thanks

frankthetank
Dirt Full Roller

Total posts: 64
posted April 26, 2005 06:13 PM  
Hey man I just got done with the same exact problem, you need to take the snout off and take it to someone who has a lathe or something and you need to turn the front of the snout down until the throwout bearing will rest on the bolts in the snout, it took me a few nights to figure it out but finally it works well. Anything else, ask, because i just got done dealing with that.

BIGDADDYBOZ
Dirt Freak

Total posts: 466
posted April 26, 2005 08:44 PM  
I got it fugured out I don't run a mid plate or mid mounts and that is where I was losing my Spacing.

How much did you gain by turning the Snout down? Thanks

    

Back to the Archives