Visit The Dirt Forum for More Information

Author Topic:   cable clutch pedal
Dirt Forum Racer

Total posts: 94
posted April 21, 2005 04:34 AM  
has anyone tried the cable type clutch assembly from jr motorsports. i need to put a clutch pedal in my car and was thinking of using this.

02 Blewbyu
Dirt Full Roller

Total posts: 48
posted April 22, 2005 03:11 PM  
I would stick to a hydraulic setup

rico 08
Dirt Forum Champ
Total posts: 1139
posted April 23, 2005 05:42 AM  
A friend of mine did this himself after having fits with the hydraulics,he just ran the cable from the fork thru the floor to a pulley by the seat..then to another pulley by the left front corner of the seat then to a floor mounted clutch good

Dirt Full Roller

Total posts: 32
posted April 23, 2005 08:16 AM  
I run a cable on one of my cars and it works great--i got one out of a cement truck--I didnt have to mess around with any pulleys just hook it up to the pedle and build a bracket off of your tranny to mount it to (make sure you mount off of the tranny because if you bend the car at all and its mounted to the frame or body your cable tension will get messed up) hope that this will help

Dirt Forum Racer

Total posts: 94
posted May 16, 2005 11:29 AM  
I installed the one from jr motorsports over the weekend. not the easiest thing to install my firewall is set back 9" and my engine 2". the cable fit by about 1/2" this thing is a good setup but the cable needs to be about 6-7" longer to be good. plus the cable comes out into the cockpit a little. just incase anyone was thinking of using one.


Back to the Archives