Visit The Dirt Forum for More Information

Author Topic:   coleman spool
Speedway65
Dirt Freak

Total posts: 344
posted April 11, 2005 10:39 AM  
We are using a coleman spool in a 7.5 metric rear end.My question is on the 2 side pieces that replace the side gears are you supposed to use the factory shims?Because when i do put them on i can't slid the 2 small blocks in place to lock everything together.Any help would be great.

[This message has been edited by Speedway65 (edited April 11, 2005).]

powerglides
Dirt Freak

Total posts: 374
posted April 11, 2005 10:49 AM  
You do not use the spider gear shims with the Coleman spool. You may even have to grind small rounded grooves into the blocks so they fit over the end of the axle enough to get the pin in. They are very good quality.

    

Back to the Archives