Visit The Dirt Forum for More Information

Author Topic:   Camaro Upper ball joint
sstocker31
Dirt Full Roller

Total posts: 30
posted April 06, 2005 08:41 AM  
While everyone is discussing this topic I might as well ask. What upper balljoint can I use to raise my rollcentre?(80 Camaro with stock A arms) I tried the Afco 20032-1 but it was to big to fit into my stock A-arm. Is there a joint that moog or somone else makes that has the extended shaft and will bolt right in? Do I need to find a lower joint as well with the extended shaft, if so, who makes that as well?

Thanks guys

[This message has been edited by sstocker31 (edited April 06, 2005).]

tilley88
Dirt Forum Champ
Total posts: 879
posted April 07, 2005 10:25 PM  
20038-1 are the lowers, but you'll have to weld 'em in. Move the left in as far as possible, the right out as far as possible. 20032-1 are the uppers, but you'll have to redrill the mounting holes in the a-arms. Spindles will have to be reamed, both upper and lower. Also, redrill the right side upper a-arm mounting holes on the frame, 1/2" lower than stock. If rules allow, run swedge tube tie-rod assemblies w/bump steer adaptors(GM).

    

Back to the Archives